Yamarin 80 Day Cruiser
16 (48)
The boat has two bilge pumps, a hand pump and an electric pump. The electric bilge pump
has a capacity of approx. 65 l/min and the hand pump has a capacity of 0.5 l/pull. Refer to the
next image to locate the pumps.
Yamarin 80 DC rainwater draining system:
1.
Drain plug
6. Drain thru fitting
2. Electric bilge pump deck thru fitting
7. Manual bilge pump
3. Manual bilge pump deck thru fitting
8. The shut-off flap
4. Drain pipe
9. Electric bilge pump
5. Rainwater drainage valve
The owner of the boat is responsible for ensuring that there is at least one baler or bucket on
the boat and that it has been secured.
WARNING!
The bilge pump system is not intended to cope with a leakage
caused by running aground or other equivalent damage.
PRECAUTION!
Refer to the next image to locate the pumps. Regularly check to
ensure that there is no debris at the end of the suction hoses for
each of the pumps. You can access the electrical pump by doing
the following: Screw off the bottom plate (plywood plate) under
the aft seat. The bilge pump is located in a case and you can just
lift it up as it is not fitted with screws. Clean out the bottom layer
in the bilge pump by letting it down into its case. The end of the
hand pump's suction hose is situated between the fuel tank and the
transom, and can be reached by screwing off the bottom plate
under the aft seat.
