Cod. 94532 – MS1600-2
12
•
Pay attention to do not touch the grounding parts, pipes, heat elements, so that to avoid electric
shock.
•
Take care of the tool. Put it in dry place when not in use, and far from children.
•
Don’t overload the tool. Operate only within the load level suggested.
•
Dress properly : Don’t wear loose clothing or jewelry because they can be caught in moving parts.
Rubber gloves and non-skid footwear are recommended when working. Wear protective hair
covering to contain long hair.
•
Use safety glasses and dust musk if operation is dirty.
•
Never carry the tool by cord or yank it to disconnect from receptacle. Keep cord far from heat, oil
and sharp edges.
•
Secure work. Use clamps or vise to hold work. It’s safer than using your hand and it frees both
hands to operate tool.
•
Keep proper footing and balance at all times.
•
Keep tool sharp and clean for better and safe performance. Follow instructions for lubricating and
changing accessories. Inspect extension cords periodically and replace if damaged. Keep handles
dry, clean and free from oil and grease.
•
Disconnect tool when not in use, before serving and when changing accessories, such as bits.
•
Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed from
tool before turning it on.
•
Avoid unintentional starting. Don’t carry plugged-in tool with finger on switch. Be sure that the
switch is off when plugging in.
•
Outdoor use extension cord. When tool is used outdoors, use only extension cords for that use
and so marked.
•
Watch what you are doing and use common sense. Don’t operate tool when tired.
•
Before further use of the tool, a guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, any other condition that
may affect its operation. A guard or other part that that is damaged should be properly repaired
or rellanced by an authorized service center unless otherwise indicated elsewhere by dealer.
•
Warning : Use not authorized spare parts of other machines can cause incidents.
Repair your tool only by Authorized Service Center.
Warning : Use not authorised spare parts of other machines can cause incidents
You must abide by certain safety precautions when using the equipment in
order to prevent injuries and damages from accuring
4.
MACHINE DESCRIPTION
1.
Switchr ON/OFF
2.
Lock button
3.
Variable speed control
4.
Speed selector
5.
Spindle thread M14
6.
Paddle
5. OPERATING INSTRUCTIONS
Before initial operating:
•Check if the rated frequency of the mains supply corresponds to the details of the type place.
• Make sure that cord and plg are in order
