Cod 52609
•
Dress properly : Don’t wear loose clothing or jewelry because they can
be caught in moving
parts. Rubber gloves and non-skid footwear are recommended when working. Wear protective
hair covering to contain long hair.
•
Use safety glasses and dust musk if operation is dirty.
•
Never carry the tool by cord or yank it to disconnect from receptacle. Keep cord far from heat,
oil and sharp edges.
•
Secure work. Use clamps or vise to hold work. It’s safer than using your hand and it frees both
hands to operate tool.
•
Keep proper footing and balance at all times.
•
Keep tool sharp and clean for better and safe performance. Follow instructions for lubricating
and changing accessories. Inspect extension cords periodically and replace if damaged. Keep
handles dry, clean and free from oil and grease.
•
Disconnect tool when not in use, before serving and when changing accessories, such as bits.
•
Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed
from tool before turning it on.
•
Avoid unintentional starting. Don’t carry plugged
-in tool with finger on switch. Be sure that the
switch is off when plugging in.
•
Outdoor use extension cord. When tool is used outdoors, use only extension cords for that use
and so marked.
•
Watch what you are doing and use common sense. Don’t operate tool when tired.
•
Before further use of the tool, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts, mounting, any other
condition that may affect its operation. A guard or other part that that is damaged should be
properly repaired by an authorized service center unless otherwise indicated elsewhere by
dealer.
•
Warning :
Use not authorized spare parts of other machines can cause incidents.
•
Repair your tool only by Authorized Service Center.
4.MACHINE DESCRIPTION
1.
Handle
2.
Protecting cover
3.
Grinding wheel
4.
Switch
5.
Block button
5. OPERATING INSTRUCTIONS
ATTENTION ! :
✓
Before set up the machine be sure that the plug is disconnected from the net
✓
Mount only correct grinding wheels
✓
Verify to have mounted correctly the flat and threaded flanges
✓
Verify that the grinding wheel is rounding according the way showed by the arrow impressed
on the machine head.
5.a Install the grinding wheel
✓
Be sure that the protecting cover (2) is surely attached to the spindle housing
✓
Put the flat flange on the spindle
✓
Put the grinding wheel
✓
Screw the threaded flange
✓
Keep fixed the spindle pressing down the block button (5) and fix the threaded flange using the
flange wrench
✓
Screw the handle into the threaded hole by the desired angle grinder side.
To remove the disk, follow the above instruction in the opposite way.
2
3
1
4
5
