16
Installation
Initial Set Up
Install the bottle
The sterilizer drains water forcibly during the “STERILIZE & DRY” process. Hot and high
pressure water will spout out to the bottle. To prevent the user from operating the sterilizer
without the drain bottle a micro switch will not allow the sterilizer to operate without the bottle.
①
Open the front door of the sterilizer and
remove the bottle. The display will flash
indicating the bottle is not in place.
②
Pour 1500ml of water into the bottle. This
water is used to cool the hot steam coming
out of the chamber.
The unit drains water forcibly out of the
container into the bottle during the
“STERILIZE & DRY” process. If too much
water is poured into the bottle, the drained
hot water can overflow. Follow the water
volume specified.
③
Put the silencer into the bottle that contains
1500ml water.
④
After the silencer is placed into the bottle,
push the bottle upward, inside the door
while
putting the exhaust hose into the bottle.
⑤
Once the bottle is set, the micro switch is
pushed, which allows the sterilizer to
operate.
Silencer
Exhaust Hose
1500ml
Plug
Silencer
Exhaust Hose
Micro Switch
