Shenzhen Yangda Security Co., Ltd
Add:3F, Block 5, Ji An Tai Industrial Area,XiHe,FuYong,
BaoAn district,ShenZhen,China, 518057
Email: info@yangdaonline.com Web: www.yangdaonline.com
Gimbal and camera control via PWM
Gimbal control
1)Yaw axis control:speed mode,connect Rocker channel(or 3 gears channel,push gear
to middle position to stop)
2)Pitch axis control:speed mode,connect Rocker channel(or 3 gears channel,push
gear to middle position to stop)
3)Mode control:angle mode,connect knob channel(or 3 gears channel)
If connecting knob channel,rotate to one end,the gimbal is at lowest speed when
controlling YAW and PITCH axis.
Rotate the knob to any position,gimbal is at higher speed when controlling YAW and
PITCH axis.
Rotate to knob to another end,gimbal back to center position.
Camera control
1)Zoom control:connect 3 gears or rocker channel
2)Focus:connect 3 gears or rocker channel for manual focus control.If do not connect
any channel,then camera will auto focus after zooming
3)PIC:connect 3 gears channel
Flip the gear from middle position to high position,record/capture model switch
Flip the gear from middle position to low position:
A:If under record mode:record start,flip from middle to low again,record stop
B:If under capture mode,capture start
4)REC:connect 3 gears channel
A: Under record mode
Flip the gear from middle to high:record start
Flip the gear from middle to low:record stop
