YZ-X5
9
● Park the machine on a flat ground and put down the scrubber;
●Rotate the plastic handle counterclockwise to remove the water retaining strip brush;
● Lift up the scrubbing brush plate, grab the bristles, lift it up slightly, shake it left and
right, and the brush plate can be removed;
When installing the brush plate, make sure that the flange plate is aligned with the
button hole of the brush plate, and the installation can be completed by rotating in any
direction.
Noted: Ride-on brush discs are made of positive and negative buckles, and the
installation can be completed no matter which direction is rotated.
●When the machine is used to clean the epoxy floor, it is necessary to replace the
ordinary brush plate with the needle plate and add a cleaning pad for cleaning, which
can effectively protect the ground from wear and tear. Please refer to the installation
instructions for operation.
3.3 Replacement and installation of the absorbent strip
●Place the machine on a flat ground, turn off the main power switch, and ensure that
the machine is powered off.
●Put down the squeegee through the handle; after rotating the plastic handle in the
opposite direction, take out the squeegee assembly.
●Unscrew the squeegee assembly nut, remove the bottom plate of the squeegee
assembly, and remove the front and rear rubber strips of the squeegee.
●Install the squeegee blade.
Step 1: Align the holes of the front rubber strip
with the protrusions of the plastic assembly of the
squeegee;
