YANGZI YZ-X6, Operating Instruction

3

Machine usage

Before the first use, adjust the equipment to the best cleaning effect.Before each 

use, routine inspection is required:

◆ Whether the seal strip of sewage tank cover comes off
◆ Is the sewage tank cleaned

1. Insert the suction pipe
Insert one end of the suction pipe into the inlet of the sewage tank and the other end 
into the exit of the tail flap.This is shown on the right

2. Fill with water
Please observe the water level through the water level pipe. If the water is insufficient,
Please fill it with clear water
◆ Open the lid of the clean water tank
◆ Put clean water into the water tank (put the water pipe into the tank first, then open 
     the water valve, the water temperature is not higher than 50℃ , the water level can be 
     observed through the water level pipe)
◆ Add detergent, the amount can be added according to the needs of the ground
◆ Close the water tank cover

3. Water regulation
◆ Open the discharge valve and adjust the water amount according to the actual needs

Pull out the rubber plug

Remove the screw with 

a Phillips screwdriver

Open the 

chassis

fuse

Relay 1: 

Control 

the brush 

motor

Relay 2: 

Control the 

suction 

motor