YANGZI YZ-X6, Operating Instruction

8

YZ-X5

Instruction Manual

Instruction Manual

separation belt. Long time will damage the sheet metal parts and drive axle of the machine..
5. The switch of the suction motor should be turned off when the machine enters the steep 
road surface to prevent splashing sewage and entering the suction tuyere, which will burn 
down the suction motor.
6. After the use of the machine, sewage should be immediately discharged, sewage tends to 
be acidic, even strong acid, no discharge of sewage on time will corroded sewage pipe, so 
that the service life of sewage pipe is reduced..
7. If the machine is not used for a long time, the machine should be fully charged and 
placed in the storage room to avoid air drying and sun exposure.
8. If the machine is not in use for more than 15 days, flush the machine with full power, 
remove the battery power line and place it in the storage room to avoid air drying and 
sun exposure.Before removing the battery power line, turn off the switch and key of the 
machine to prevent electric shock.
9. In the cleaning process of the machine, the key switch should be turned off first. It is 
strictly prohibited to flush the battery, motor, wiring harness, controller computer board 
and other positions directly from the water pipe.
10. After the machine is finished working, let the battery of the machine cool down before 
charging, the continuous charging time should not exceed 10 hours, if no one is watching, 
it is recommended to equip with intelligent timing socket.
11. Charge the machine in a ventilated and warm condition. Do not charge it in a high 
temperature sealed environment to prevent the battery from bulging at high temperature
12. The battery of the machine must be charged with the original charger provided by 
our company. It is forbidden to use fast charging, high voltage charging and low voltage 
charging, which will cause the battery to bulge
13. When the machine is equipped with detergent, defoaming agent must be added to 
the sewage tank for defoaming to prevent the sewage bubble from being sucked into the 
suction motor and burning the motor
14. The towing machine should be suitable for 1.5-2 hours in continuous use. If it needs to 
work for a long time, wait for the motor temperature to cool down before starting to work
15. The sequence of starting machine switches is: main power switch → brush plate switch 
→ water absorption switch. Inversion will cause instantaneous current to be too large and 
burn down the voltage display table.
16. During continuous operation of the machine, do not switch on and off at times, which 
will lead to excessive starting current for many times, accelerate insulation aging of the 
motor, and reduce the service life of the motor