10
YZ-X7
Battery charging
NOTE: In order to extend the battery life and ensure the best performance of the machine,
the battery must be charged for less least 30 minutes. Do not leave the battery unused
for a long time. The following charging instructions apply to the charger attached with
this machine. Be sure to use the following specification charger to avoid damage to the
battery.
Battery charger specification:
● Charger Type: Charger for one lead-acid battery
● output voltage of 1 24 volts
● output current: 115 amp
● automatic power-off circuit
● for deep cycle battery charging
1.
Move the machine to a well-ventilated place for charging.
Warning: Fire or explosion hazard. The battery releases the hydrogen gas. Please far high spark or open
source. Keep the battery compartment open when charging.
2.
Park the machine on the level ground and turn the key to the closed position.
3.
Check the electrolyte level in each battery unit before charging.
For safety: when repairing the machine, wear protective gloves and protective equipment when
handling the battery and battery wiring. Avoid contact with the battery liquid acid.
4.
When charging, please open the sewage tank side for good ventilation
5.
Insert the charger's AC (AC) power cord into a well-grounded power outlet.
6.
Insert the DC (DC) cable of the charger into the battery charging outlet at the rear of the
sewage tank.
7.
The charger will automatically start charging and will automatically turn off when full.
Note: The machine will not operate with the charger. NOTE: During the charger charging, do not
unplug the charger Dc cable from the outlet on the machine to avoid arc discharge. If charging must be
suspended while charging, unplug the AC power cable first.
Warning:Fireorexplosionhazard.Thebatteryreleasesthehydrogengas.Stayawayfromsparksoropen
fire sources. Keep the battery compartment open when charging.
8.
After charging, check the electrolyte level height again.
