17. Re-power on tracker
Send SMS “reset#” to tracker can make the tracker power off and power on again, some time
the tracker can not online, send the reset command, the tracker will re-power on a few minutes later.
18. Restore to factory setting (Back to Default)
Send SMS “factory#” to the tracker, the tracker will delete all user setting, and restore all setting
to factory mode, just like a new tracker, and the tracker will repower on after delete user setting. If the
user have changed the setting, such as APN, IP, center number, etc, you need set this again after back
to factory mode.
Platform Operation Please Refer Platform Operation Guide
Notes:
1.
Please confirm that the SIM card PIN code has been disabled, it means if mobile phone use
this SIM card, it is not necessary to input any password. Otherwise the tracker can not find
GSM network, the Green LED will keep ON .
2.
This tracker use 2G GSM network, and it upload tracking only through 2G GPRS, it can not
work in CDMA network or 3G(WCDMA or CDMA2000) network, if the 3G SIM card can use in
2G GSM network, then the SIM card can be used in this tracker.
3.
The antenna of GSM and GPS is built in tracker, please note that the install location of the
tracker must can receive the GPS signal, normally the back of the seat or arm rest box or
under the back window or room on the panel etc. please leave away the tracker from big
metal, and keep away from the magnetic components.
4.
The tracker built in backup rechargeable Li battery, the battery can be used 5-10 hours after
the power supply is disconnected.
5.
The GPS need 10-200 seconds to locate the position, when the GSM signal is weak or the
network is very busy, the SMS maybe delay to send by the GSM network, this is normal.
6.
The tracking data on our server will keep 6-12 months, the old data will be deleted.
Trouble Shooting
