automatically.
When power is OFF, please press the “ON-OFF” button beside the tracker case, till the RED LED
is ON or FLASH, release the button and the tracker is power ON.
When power is ON, please press the “ON-OFF” button beside the tracker case, till the RED LED
is OFF, release the button and the tracker is power OFF.
When the battery voltage in the tracker is too low, the tracker will power off automatically.
2. Install SIM card
Unfasten the screw on the back case of the tracker, and open the case of the tracker , the SIM
card holder will be seen, pull the metal cover to “OPEN” direction, and the cover can be opened up,
and put the SIM card in the holder (Metal pin face to down), close the metal cover and push the metal
cover to “LOCK” direction, after a sound of lock the SIM card has been locked and installed.
Up to Open
Down to Lock
Unfasten Screw
Sim Card Metal Pin Face to Down
Note: 1. This tracker use 2G GSM network, and it upload tracking only through GPRS, it can not
work in CDMA network or 3G(WCDMA or CDMA2000) network. (Some 3G SIM card
can use in 2G GSM network, this kind of 3G SIM card can use in this tracker)
2. Please confirm the PIN code of the SIM card is disabled (insert the SIM card to mobile
phone and can be disabled in mobile phone setting menu).
3. Before installing or uninstalling the SIM card, please power off the tracker.
3. ANTENNA
The Antenna of GSM and GPS are built in the tracker.
Pleas leave the tracker away from big metal, this will reduce the GSM and GPS signal. And the
GPS antenna need faced to heaven, otherwise the GPS signal will be weak and maybe can not
located.
4. Waterproof
The design of the tracker is IP56 level waterproof, it means the raining or sprinkling can not
damage the tracker, but you can not drop the tracker into water.
5. Using Condition
