The working temperature is -20
0
C to 60
0
C, over this range the specification maybe can not reach
the standard level, the storage temperature can reach to -40
0
C to 80
0
C.
6. Back to factory setting (Default configuration)
First send SMS (pw,123456,center,yourphonenumber#) to the tracker to set your mobile phone
number as center or slave center number, then sending SMS (factory#) to the tracker will delete all
user setting and back to factory configuration and repower on.
Notes: After back to default set, all IP / APN / GPRS / Language / Timezone / Alarm Setting
etc are deleted and back to factory setting, just like a new product, all preset phone number
are deleted and password change to 123456, all the alarm setting is canceled, if the
IP/APN/GPRS name & password/TIMEZONE are changed, and you need set these again by
sending SMS.
How to Install
1. Connect the P1 to the car battery / ACC and immobilizer, and P2 & P3 to the external
microphone & SOS button, the wire of the P1 P2 & P3 are as follow.
P3: External Microphone, insert the microphone to the socket is OK, please install the
microphone close to driver but driver can not see the microphone.
P2: External SOS button, insert the microphone to the socket is OK, and please install the SOS
button close to driver and the driver can press or step by hand or foot, but it can not be pressed by
mistake very easy.
P1: Power supply & ACC / Immobilizer.
RED: Power supply, 9-40V, Connect to the car battery is OK, and the fuse on the red wire
can not be removed.
BLACK: GND or Car body.
WHITE: ACC Signal, Positive Trigger Input, ACC can control the location uploading.
YELLOW: turning OFF car engine control, Cut Relay Driving (Immobilizer Control) output,
Negative output (500mAH driving capacity), if user like to control the car engine off, a cut relay is
necessary to install to control the car engine, the installation please refer the following.
