Attention: Turning off engine is very dangerous when car is driving, this will
make the car difficult to control and maybe cause a accident, so we recommend make
the relay cut the start motor wire, this will make you can not remote turn off car engine,
but you can make the car engine can not be started.
2. Installation Place on the vehicle
The tracker should be installed in the hidden place, then it is not easy to be broken and
removed, because the GPS & GSM antenna are built in the tracker, so you should confirm the
installation place have good GPS and GSM signal, the GPS antenna should face to sky, and it can
not face to ground, please keep the tracker away from the big metal, we recommend install the
tracker under the front panel of the car, or under the rear panel or under the rear glass, or in the pillar
beside the driver seat etc. And please fasten the tracker to the car body with adhesive tape or other
tape, and keep away from the other auto accessory.
3. Upload tracking control & built in battery
After the tracker is powered on, the tracker will begin to work automatically, and the built in
battery will be recharged automatically, after the backup battery is full, the built in recharging circuit
will stop recharging. The tracking upload is controlled by ACC signal & shock sensor, if the car engine
is turned on or the tracker begin to move, the tracker begin upload the tracking, the tracker status on
the platform will change to online immediately. if the car engine is turned off or the tracker stop
moving, the tracker will stop upload the tracking , after 10 minutes the tracker status on the platform
will change to offline. If you like to keep the tracker always online, send SMS to change is OK, but this
will exhaust more data charge and car battery power.
How to Use
1. First to buy a 2G GSM phone SIM card, which needs SMS service and incoming caller ID
