BEFORE YOU OPERATE
2V Operation Manual
37
Checking Engine Oil
1. Make sure engine is level.
2. Remove oil cap / dipstick
(Figure 4, (1))
and
wipe with clean cloth.
Figure 4
3. Fully reinsert oil cap / dipstick
but do not
screw in
.
4. Remove oil cap / dipstick. The oil level should
be between upper
(Figure 4, (2))
and lower
(Figure 4, (3))
lines on the oil cap / dipstick.
5. Fully reinsert oil cap / dipstick
(Figure 4, (1))
and hand-tighten. Over-tightening the oil
cap / dipstick will damage it.
Adding Engine Oil
1. Make sure engine is level.
(Figure 5, (1))
.
Figure 5
3. Add indicated amount of engine oil at the side
engine oil filler port
(Figure 5, (2))
.
4. Wait three minutes and check oil level.
5. Add more oil if necessary.
(Figure 5, (1))
and
hand-tighten. Over-tightening may damage the
cap.
0002421
(1)
(2)
(
3
)
(2)
0002421B
(1)
Summary of Contents for 0A2V000-U0000
