ALTERNATOR
TNV IDI Service Manual
11-13
Alternator
3. Position the stator assembly
(Figure 11-13, (1))
on the front frame housing studs.
4. Lubricate the shaft of the rotor assembly
(Figure 11-14, (1))
. Press the rotor assembly
into the front frame housing
(Figure 11-14, (2))
and rear frame housing
(Figure 11-14, (3))
.
Figure 11-14
5. Align the front frame housing with the rear
frame housing. Reinstall the two bolts
(Figure 11-15, (1))
and two nuts
(Figure 11-15, (2))
.
Figure 11-15
6. Reinstall the insulation bushing
(Figure 11-16, (4))
and nut
(Figure 11-16, (3))
.
Figure 11-16
7. Reassemble the regulator assembly
(Figure 11-16, (1))
to the holder
(Figure 11-16, (2))
.
8. Reinstall the brush holder
(Figure 11-17, (3))
,
springs
(Figure 11-17, (4))
and brushes
(Figure 11-17, (5))
.
9. Reattach the regulator assembly and holder to
the rear frame housing.
Figure 11-17
10. Reinstall the rear cover
(Figure 11-17, (2))
to
the rear frame housing with three bolts
(Figure 11-17, (1))
.
100266A
2
1
3
0000265A
1
2
3
4
1
2
0000258A
3
4
5
1
2
0000257A
TNV_IDI_ServiceManual_A4.book 13 ページ ２０１２年２月２４日 金曜日 午前１０時２４分
