PERIODIC MAINTENANCE
5-16
TNV IDI Service Manual
Periodic Maintenance Procedures
2. If the governor lever does not make proper
contact with the high idle stop or the low idle
speed limit screw, adjust the throttle cable or
linkage as necessary.
Note: DO NOT FORCE the throttle cable or
linkage to move. This may damage the
the governor lever, the throttle cable or
linkage and cause irregular operation of
the engine speed control.
IMPORTANT
The engine speed control (throttle lever,
accelerator pedal etc.), should be equipped
with stops to prevent the application of
excessive pressure by the governor lever to
either the high idle stop or low idle speed
limit screw.
Figure 5-11
Clean Air Cleaner Element
Note that a typical air cleaner is shown in
Figure 5-12
and
Figure 5-13
for illustrative
purposes only.
The engine performance is adversely affected
when the air cleaner element is clogged with dust.
Be sure to clean the air filter element periodically.
NOTICE
• When the engine is operated in dusty conditions,
clean the air cleaner element more frequently.
• NEVER operate the engine with the air cleaner
element(s) removed. This may allow foreign
material to enter the engine and damage it.
1. Unlatch and remove the air cleaner cover
(Figure 5-12, (1))
.
2. Remove the element
(Figure 5-12, (2))
(outer
element if equipped with two elements).
Figure 5-12
(2)
(3)
(1)
0000070A
(3)
(6)
(4)
(2)
(5)
(1)
TNV_IDI_ServiceManual_A4.book 16 ページ ２０１２年２月２４日 金曜日 午前１０時２４分
