![background image](http://html.mh-extra.com/html/yanmar/3tnv-series/3tnv-series_service-manual_905550131.webp)
7. Fuel Injection Pump/Governor
7.2.4 Assembly procedure
Reverse the disassembly procedure and adjust the fuel injection timing finally. See (4) of 2.2.7.
7.2.5 Servicing points
Point 1
[Disassemble]
Block an entrance with the tape so that trash may
not enter the fuel injection pipe and the fuel
injection pump.
Point 2
[Disassemble]
After putting the I.D. marks on the gearing part of
the pump drive gear and the idle gear with paint
and so on, remove the gear installation nut.
[NOTICE]
Don't remove four flange bolts.
[Reassemble]
Reassemble the pump driving gear while checking the I.D. marks on the driving gear and idle gear.
Tightening torque of the gear installation nut
Model N m(kgf m)
Lubricating oil application
(thread portion, and seat surface)
TNV82A 88 78 88 (8 9)
4TNV94 106(T) 113 123 (11.5 12.5)
Not applied
116
Summary of Contents for 3TNV Series
