![background image](http://html.mh-extra.com/html/yanmar/3tnv-series/3tnv-series_service-manual_905550142.webp)
8. Turbochager
8.4 Disassembly Procedure
8.4.1 Preparation for disassembly
In addition to the general tools, the following special tools are required for turbocharger disassembly
and reassembly:
Tool name
Use
Illustration
Bar
For removing thrust bearing and
thrust bushing
Material: Copper or brass
Pliers
For removing floating bearing circlip
Pliers
For removing seal ring
Torque driver for TORX bolt
(multifunctional type)
0.5 to 4.9N-m (5 to 50 kgf-cm)
For thrust bearing installation
(for M3):1.3 N-m (13 kgf-cm)
For seal plate installation
(for M3):1.3 N-m (13 kgf-cm)
Item sold on market
(Type: TORX TT20 or equivalent)
Box wrench
For fixing turbine shaft
(mm dodecagonal)
Box only may be used.
Torque wrench
(single purpose)
For following bolts and nuts:
M8:mm, kgf-cm(N-m)
M5:mm, kgf-cm(N-m)
M5:mm, kgf-cm(N-m)
Probe
For measuring play in axial and radial directions: To be installed on a dial
gage
127
Summary of Contents for 3TNV Series
