![background image](http://html.mh-extra.com/html/yanmar/3tnv-series/3tnv-series_service-manual_905550057.webp)
2. Inspection and Adjustment
Push the bridge head so that a valve bridge and
two valve stem heads may contact each other
uniformly, and adjust an adjusting bolt so that a
gap of the valve stem head may become 0.
Tighten a locknut after a valve bridge is fixed with
a wrench.
2) Measuring valve clearance
Insert a 0.2 or 0.3 mm thickness gage between
the rocker arm and valve cap / valve bridge, and
adjust the valve clearance. Tighten the adjusting
screw.
mm
Model
Standard valve clearance
3TNV82A 98 0.15 0.25
4TNV106(T) 0.25 0.35
[NOTICE]
When tightening a valve bridge locknut of 4-valve
head, tighten a locknut after fixing a valve bridge
with a wrench so that a bridge may not rotate and a
valve may not lean.
3) Apply oil to the contact surface between adjusting
screw and push rod.
4) Adjusting other cylinders
In case of 4-cylinder engines turn the crankshaft
180 then and make adjustment for the No.3
cylinder. Then adjust the No.4 and No.2
cylinders in this order.
The cylinder to be adjusted first does not have to
be the No.1 cylinder. Select and adjust the
cylinder where the piston is the nearest to the top
dead center after turning, and make adjustment
for other cylinders in the order of ignition by
turning the crankshaft 180 each time.
In case of 3-cylinder engines turn the crankshaft
240 then and make adjustment for the No.3
cylinder. Then adjust the No.2 cylinder in this
order.
The cylinder to be adjusted first does not have to
be the No.1 cylinder. Select and adjust the
cylinder where the piston is the nearest to the top
dead center after turning, and make adjustment
for other cylinders in the order of ignition by
turning the crankshaft 240 each time.
42
Summary of Contents for 3TNV Series
