ENGINE
6-58
TNV DI Service Manual
4-Valve Cylinder Head
If distortion exceeds the service limit, resurface or
replace the cylinder head. Remove only enough
material to make the cylinder head flat, but do not
remove more than 0.008 in (0.20 mm).
Inspection of Intake and Exhaust Valves
Visually inspect the intake and exhaust valves.
Replace any valves that are obviously discolored,
heavily pitted or otherwise damaged.
Valve Stem Diameter
Use a micrometer to measure the valve stem
diameter. Measure the valve stem near the
combustion end and near the opposite end
(Figure 6-56, (1)). See Intake / Exhaust Valve and
Guide on page 6-7 for the service limit.
Figure 6-56
Valve Stem Bend
Place the valve stem on a flat inspection block or
layout bed. Roll the valve until a gap can be
observed between a portion of the valve stem and
the surface of the block or bed. Use a feeler gauge
to measure the gap (Figure 6-57). See
Intake / Exhaust Valve and Guide on page 6-7 for
the service limit.
Figure 6-57
Valve Recession
Note: The valve guides must be installed to
perform this check.
Insert the valves into their original locations and
press them down until they are fully seated. Use a
depth micrometer (Figure 6-58) to measure the
difference between the cylinder head gasket
surface and the combustion surface of each
exhaust and intake valve (Figure 6-59). See
Cylinder Head on page 6-6 for the service limit.
Figure 6-58
Note: 2-Valve cylinder head is shown. 4-Valve
cylinder head is similar.
0000197
(1)
0000199
0000193
TNV_DI_SM_A4.book 58 ページ ２００７年１２月６日 木曜日 午前９時２３分
Summary of Contents for 3TNV82A-B
Page 8: ...INTRODUCTION 1 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
Page 18: ...SAFETY 3 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
Page 320: ...TURBOCHARGER 10 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
