ENGINE
6-78
TNV DI Service Manual
Crankshaft and Camshaft Components
6. TNV84 - TNV88: Remove the O-ring
(Figure 6-99, (2)) and dowels
(Figure 6-99, (5)).
Figure 6-99
Disassembly of Crankshaft and
Piston Components
Removal of Pistons
IMPORTANT
Engines with high operating hours may
have a ridge near the top of the cylinders
that will catch the piston rings and make it
impossible to remove the pistons. Use a
suitable ridge reamer to remove ridges and
carbon prior to removing the pistons.
Note: Pistons can fall from cylinder block if the
engine is inverted. Rotate the engine so
the connecting rods are horizontal before
removing the connecting rod caps.
1. Using a feeler gauge, measure the connecting
rod side clearance as shown (Figure 6-100).
See Connecting Rod on page 6-22 for the
standard limit. If the measurement is out of
specification, replace the crankshaft,
connecting rod, or both.
Figure 6-100
2. Measure bearing oil clearance prior to removing
the pistons and connecting rods to determine
extent of wear. Record the measurements.
CAUTION
Keep the piston pin parts, piston
assemblies, and connecting rod
assemblies together to be returned to
the same position during the
reassembly process. Label the parts
using an appropriate method.
0000088en
0002016
(1)
(3)
(4)
(2)
(5 )
0000219
TNV_DI_SM_A4.book 78 ページ ２００７年１２月６日 木曜日 午前９時２３分
Summary of Contents for 3TNV82A-B
Page 8: ...INTRODUCTION 1 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
Page 18: ...SAFETY 3 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
Page 320: ...TURBOCHARGER 10 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
