FUEL SYSTEM
7-12
3TNV88F Service Manual
Fuel Injection Pump
9. Remove the fuel supply line
.
Plug the open end of the line to minimize
leakage and prevent contamination.
Figure 7-8
10. Remove the solenoid valve connector
, rack actuator connector
, and engine speed sensor
connector
.
11. Remove the rear fuel injection pump bracket(s)
from the fuel injection pump.
Note: Configuration of the fuel injection pump
rear brackets may vary depending upon
engine model.
12. Disconnect the lube oil line
(Figure 7-9, (1))
and the clamp
from the pump.
NOTICE
Take care to not damage or bend the oil line. In
some applications, it may be preferable to
remove the complete oil line assembly from the
engine before proceeding.
Figure 7-9
13. Remove the fuel injection pump drive gear
cover
from the gear case
cover
.
Note: The fuel injection pump drive gear cover
is secured with an adhesive sealant. Use
a gasket scraper to separate the fuel
injection pump cover from the gear case
cover.
Figure 7-10
1
2
3
4
5
6
K0000593B
1
2
2
1
046373-00X00
3TNV88F_SVM_A4.book 12 ページ 2012年7月26日 木曜日 午後6時4分