ALTERNATOR
3TNV88F Service Manual
11-13
Alternator
2. If removed, lubricate the outside diameter of a
new front frame housing bearing. Press the
bearing
into the front frame
housing. Reinstall the plate
(Figure 11-13, (4))
to the front housing. Tighten the four bolts
(Figure 11-13, (3))
.
Figure 11-13
3. Position the stator assembly
on the front frame housing studs.
4. Lubricate the shaft of the rotor assembly
(Figure 11-14, (1))
. Press the rotor assembly
into the front frame housing
and rear frame housing
.
Figure 11-14
5. Align the front frame housing with the rear
frame housing. Reinstall the two bolts
and two nuts
.
Figure 11-15
6. Reinstall the insulation bushing
and nut
.
Figure 11-16
7. Reassemble the regulator assembly
to the holder
.
8. Reinstall the brush holder
(Figure 11-17, (3))
,
springs
and brushes
.
1
2
4
3
K0000259A
K100266A
2
1
3
K0000265A
1
2
3
4
1
2
K0000258A
3TNV88F_SVM_A4.book 13 ページ 2012年7月26日 木曜日 午後6時4分