LUBRICATION
Repair
12/05
BY Service Manual
8-11
© 2009 Yanmar Marine International
Remove and Install Oil Filter Housing
1. Drain engine oil. See Change Engine Oil and
Replace Engine Oil Filter Element on page 8-9.
2. Drain engine coolant. See Drain and Fill Closed
3. Remove oil filter cartridge. See Change Engine
Oil and Replace Engine Oil Filter Element on
page 8-9.
4. Remove coolant pipe retaining bolt
Figure 8-12
Figure 8-12
5. Disconnect coolant pipe (Figure 8-12, (2)) from
thermostat housing.
6. Disconnect coolant pipe hose
(Figure 8-13, (1)) from oil cooler
(Figure 8-13, (2)).
Figure 8-13
Figure 8-13
7. Remove coolant pipe (Figure 8-14, (1)) from
engine.
Figure 8-14
Figure 8-14
8. Remove bolt (Figure 8-14, (2)) securing
dipstick tube to oil filter housing.
9. Remove three bolts (Figure 8-14, (3)) and
remove oil filter housing from engine.
10. Install a new seal and install oil filter housing.
11. Connect the coolant pipe and secure the
dipstick tube.
12. Add coolant. See Drain and Fill Closed Cooling
13. Install the filter cover and filter. Tighten to
25 N·m (221 in.-lb).
14. Add engine oil. See Change Engine Oil and
Replace Engine Oil Filter Element on page 8-9.
15. Start the engine and inspect for leaks.
Remove and Install Oil Sump
1. Drain engine oil. See Change Engine Oil and
Replace Engine Oil Filter Element on page 8-9.
2. Remove bolt securing oil dipstick tube to oil
filter housing. Remove oil dipstick tube from oil
pan.
000
3
766
(1)
(2)
000
3
7
9
0A
(1)
(2)
000
3
7
93
(1)
(2)
(
3
)
