CL600 Operator's Manual
(A) Implement control lever
(a) Lower
(b) Float
(c) Dump
(d) Raise
(e) Curl
■
Use the Implement Control Valve
Picture Note:
The standard label may not exactly match the label
on the tractor.
The label installed on the tractor next to the
implement control lever shows the different lever
positions.
Lever positions numbered 1-4 on the label match the
hydraulic line couplers numbered 1-4 on the label for
the coupler installed on the tractor near the couplers.
The table below specifies that moving the lever to
position 1 supplies fluid to coupler 1 and return fluids
through coupler 2 and so forth.
(A) Hydraulic quick coupler
Move the implement control lever to the full forward
or float position to:
●
Remove the pressure in both lines 3 and 4.
●
Allow the transmission hydraulic oil to flow back
and forth between the lines.
The implement control lever may be left in the float
position.
■
Use the Implement Control Lever Lock
The following procedure prevents accidental
operation of the loader.
(A) Implement control lever lock
(a) Locked position
(b) Unlocked position
●
Move the implement control lever lock to forward
position (a) as shown. The preceding operation
inhibits any implement control lever movement.
The implement control valve cannot be operated.
●
Move the implement control lever lock (A) to the
backward position (b). The preceding operation
allows the implement control lever to move in all
directions. The implement control valve can be
operated.
Lever Position
Fluid Supply
to Coupler
Fluid Return
to Coupler
Left to position 1
1
2
Right to position 2
2
1
Forward to position 3
3
4
Rearward to position 4
4
3
(b)
(c)
(e)
(A)
(d)
(a)
P5-3 top view_1
㻝㻭㻤㻞㻡㻜㻙㻢㻡㻠㻝㻜
㻏
㻏
㻏
㻝
㻞
㻟
㻠
2
1
3
4
P1110438 (2).eps
(3)
(1)
(2)
(4)
(A)
450_009_ICLLock
(A)
(a)
(b)
Summary of Contents for CL Series
Page 46: ...NOTE...