Page ii
© Yanmar 2008
Electronic Control System:
Operation Manual for SY Series Engines with GEN III Controls
All information, illustrations and specifications in this manual are based on the latest information available at the time of
publishing. The illustrations used in this manual are intended as representative reference views only. Moreover, because
of our continuous product improvement policy, we may modify information, illustrations and / or specifications to explain
and/or exemplify a product, service or maintenance improvement. We reserve the right to make any change at any time
without notice. Yanmar and
are registered trademarks of Yanmar Co., Ltd. in Japan, the United States
and/or other countries.
Safety alerts alone cannot eliminate the hazards that they signal. Strict compliance to these special instructions when
performing installation, operation, and maintenance is the most effective accident prevention measure along with exercising
care and using common sense when performing such actions.
Maximum performance, and compliance with the EMC Directive, can only be ensured by correct installation.
It is strongly recommended that the installation conforms with the following standards:
APPLICABLE STANDARDS
a) ISO 8846 Small Craft-Electrical Devices
Protection against ignition of surrounding flammable gases.
b) ISO = International Standards Organization
SAFE BOATING STATEMENT
This device meets or exceeds the applicable ABYC, ISO, and USCG safe boating rules, regulations, standards, and
guidelines.
SAFE BOATING ON THE WEB
U.S. Coast Guard
www.uscg.mil
U.S. Power Squadron www.usps.org
American Boat & Yacht Council (http://www.abycinc.org)
NMEA 2000® is a registered trademark of the National Marine Electronics Association.
NOTICE TO INSTALLER
RECREATIONAL CRAFT DIRECTIVE 94/25/EC
All Rights Reserved:
No part of this publication may be reproduced or used in any form by any means - graphic, electronic, or mechanical,
including photocopying, recording, taping, or information storage and retrieval systems - without the written permission
of Yanmar Marine International.
Summary of Contents for i8350
Page 28: ......
