PERIODIC MAINTENANCE
JH Series Operation Manual
119
8. Approximately 10 minutes after
stopping the engine, remove the oil
dipstick and check the oil level. Add oil
if the level is too low.
NOTICE
Be careful not to get any oil on the
V-ribbed belt. Oil on the belt causes
slipping and stretching. Replace the belt
if it is damaged.
Changing the Marine Gear Oil and
Replacing the Marine Gear Oil Filter
(If Equipped)
Figure 3
Note: 4JH80/4JH110 engines with KMH4A
marine gear shown. Refer to the
Operation Manual for the marine
gear or sail drive for procedure.
1. Remove cap from the filler port and
attach an oil drain pump. Drain marine
gear oil.
NOTICE
Always be environmentally responsible
.
2.
KMH4A Marine Gear:
Wash the marine gear oil filter:
(a) Remove side cover
(Figure 3, (5))
and remove the filter
(Figure 3, (2))
.
(b) Clean the filter thoroughly with
kerosene or clean diesel fuel.
(c) Hold the filter in place with the coil
spring
(Figure 3, (3))
and insert into
the case. Install a new O-ring
(Figure 3, (4))
in the side cover.
(d) Install side cover and tighten side
cover bolts.
3. Fill marine gear with clean marine gear
oil.
See Marine Gear Oil Specifications
.
4. Perform a trial run and check for oil leaks.
5. Approximately 10 minutes after
stopping the engine, remove the oil
dipstick and check the oil level. Add oil
if the level is too low.
Checking and Adjusting the
Alternator V-ribbed belt Tension
WARNING
Sever Hazard
Perform this check with the power
switch off and the battery switch turned
off to avoid contact with moving parts.
NOTICE
• When there is not enough tension in the
V-ribbed belt, it will slip and the coolant
pump will fail to supply coolant.
Engine overheating and seizure will
result.
• Never get any oil on the belt(s). Oil on
the belt causes slipping and stretching.
Replace the belt if it is damaged.
2
3
4
5
1
K0004495
3JH40_4JH45_4JH57_4JH80_4JH110_EN_OPM.book 119 ページ ２０２２年９月２２日 木曜日 午後６時１７分
