PERIODIC MAINTENANCE
122
JH Series Operation Manual
Adjusting Trolling Remote Control
Handle - If Equipped
Figure 10
1 – Cable Fitting
2 – Trolling Lever
3 – Low Speed (trolling)
4 – High Speed
5 – Loosen
6 – Tighten
7 – Normal Operation (high speed)
8 – Trolling (low speed)
Note: KMH4A marine gear shown.
1. Ensure that the trolling lever
is in the high-speed
position when the
trolling remote control handle is in
high-speed position
(Figure 10, (7))
.
2. Ensure that the trolling lever is in the
low-speed
(Figure 10, (3))
position
when the trolling remote control handle
is in low-speed position
.
3. To adjust, loosen the adjustment screw
of the cable fitting
and
adjust the position of the cable.
Adjusting Propeller Shaft Alignment
The flexible engine mounts are
compressed slightly during initial engine
operation and may cause misalignment
between the engine and the propeller
shaft.
After the first 50 hours of operation, the
alignment should be checked and
readjusted if necessary. This is considered
normal maintenance and the adjustment
requires specialized knowledge and
techniques. Consult your authorized
YANMAR Marine dealer or distributor.
Check for any unusual noise and vibration
in the engine/boat hull, while increasing
and decreasing the engine speed
gradually.
If there is unusual noise and/or vibration,
this maintenance requires specialized
knowledge and techniques.
Consult authorized YANMAR Marine
dealer or distributor to adjust the propeller
shaft alignment.
1
2
3
4
5
6
7
8
057454-00X00
3JH40_4JH45_4JH57_4JH80_4JH110_EN_OPM.book 122 ページ 2022年9月22日 木曜日 午後6時17分