ENGINE OPERATION
72
JH Series Operation Manual
OPERATION (VC10: VESSEL
CONTROL SYSTEM)
Starting the Engine
1. Open the seacock (if equipped).
2. Open the fuel tank cock.
3. Turn the battery switch on for engine
and engine control system.
4. Press the Power switch on the switch
panel of the selected station
(Figure 8, (1))
.
• The switch panel lamp will come on,
will come on or flash.
• To use the Engine START/STOP
switch, be sure to turn the Power
switch ON.
Figure 6
Figure 8
5. If the “Sys on by ID” has been set, enter
the password into the display.
6. Press the control head “SEL” switch.
• Wait until the display shows the engine
data. The display is shown.
7. If the “Start by ID” has been set, enter
the password into the display.
• The “Start by ID” has been set, the
engine can be started in 10 seconds
after entering the password into the
display.
8. Move the remote control handle to the
N (Neutral) position.
Figure 7
Figure 9
Figure 8
Figure 10
2
4
3
1
037627-00X01
SEL
NEUTRAL
PORT
STBO
NTRL
SYNC
TROL
037639-00X00
Control head panel
037638-00X00
3JH40_4JH45_4JH57_4JH80_4JH110_EN_OPM.book 72 ページ ２０２２年９月２２日 木曜日 午後６時１７分
