PERIODIC MAINTENANCE
70
L-N Operation Manual
Figure 5
10. Recheck the engine oil level by fully inserting,
but not screwing in, the dipstick.
11. Add engine oil
(Figure 5, (4))
as needed until
the level is between the upper
(Figure 5, (2))
and lower lines
(Figure 5, (3))
on the oil cap /
dipstick
(Figure 5, (1))
.
12. Replace the oil cap / dipstick
(Figure 5, (1))
and tighten by hand. Over-tightening may
damage the cap. If any engine oil is spilled,
wipe it away with a clean cloth.
Perform the following maintenance every 50
hours of operation.
• Clean Inlet Fuel Screen
Clean Inlet Fuel Screen
1. Clean the area around the fuel cap
(Figure 6, (1))
.
2. Remove the fuel cap
from the
.
(1)
(2)
(
3
)
(4)
0001119A
(1)
0001566A
Every 50 Hours of Operation
A
DANGER
FIRE AND EXPLOSION HAZARD!
• Diesel fuel is extremely flammable and
explosive under certain conditions.
• When you remove any fuel system
component to perform maintenance
(such as changing the fuel filter) place
an approved container under the
opening to catch the fuel.
• NEVER use a shop rag to catch the
fuel. Vapors from the rag are extremely
flammable and explosive.
• Wipe up any spills immediately.
• Wear eye protection. The fuel system
is under pressure and fuel could spray
out when you remove any fuel system
component.
• Failure to comply will result in death or
serious injury.
0000009en
LN Series OperationManual_A4.book 70 ページ ２００６年５月１２日 金曜日 午前１０時１８分
