Lx410/450/490 Operator's Manual
2. Avoid exceeding the maximum vertical load of
1102
lb. (500
kg) on the drawbar.
3. The strain is greatly increased by high speed and
rough ground.
■
Deploy/Stow the Drawbar
1. Remove the hairpin clip.
2. Remove the pin.
3. Set the drawbar length by lining up the positioning
hole (a) in the drawbar with that in the drawbar
bracket.
(A) Hairpin clip
(B) Pin
(a) Hole for attaching the drawbar in the operating
state (deployed position)
(b) Hole for attaching an implement
(c) Hole for most pulled away position
(C) Drawbar
4. Set the drawbar length by lining up the hole (a) in
the drawbar with the corresponding hole in the
drawbar bracket.
5. Install the pin.
6. Install the hairpin clip.
■
Remove Drawbar
1. Remove the hairpin clip.
2. Remove the pin.
3. Remove the drawbar.
4. Install the pin to the drawbar.
5. Install the hairpin clip.
6. Keep the drawbar to the storage area.
1. Use the appropriate adapter parts to connect the
safety chain to the tractor drawbar support and to
the towed implement.
• Allow enough slack in the safety chain to enable
turning.
2. As necessary, mount additional intermediate
support for the safety chain on the drawbar to
eliminate excessive slack.
• Remove and store the safety chain when not in
use.
IMPORTANT
●
Make sure that the drawbar is removed before
using the Power Take Off (PTO) driven/drawn
implement.
NOTE
To secure the drawbar in the stowed position while
Power Take Off (PTO) driven implement is not
used:
●
Remove the hairpin clip.
●
Slide the drawbar in, until the positioning hole (b)
is align with the hole in the drawbar bracket.
●
Install the hairpin clip.
P1110518
(A) (B)
(C)
(a)
(b)
(c)
3. Use the Safety Chain
Avoid injury!
●
Always hitch loads being towed to the
drawbar.
●
The preceding action prevents the tractor
from tipping over to the rear.
●
Never use the safety chain alone to tow a
load.
IMPORTANT
●
Always secure the towed implement to the
drawbar.
• the safety chain is only intended to control the
towed implement if the towed implement is
accidentally disconnected from the drawbar
●
Always use a chain whose strength is rated
greater than the gross weight of the towed
implement.
●
Always replace or repair the safety chain if any of
the chain link/s or connector/s is/are broken,
elongated or damaged.
! WARNING
