![background image](http://html.mh-extra.com/html/yanmar/rt70/rt70_operators-manual_905645172.webp)
RT70 Operator’s Manual
Maintenance - 171
Microtrencher Procedures
Blade and Bits
MT12
Check bits for wear every 100ft (30.5m). Replace worn bits as needed.
Check wear bars and hard-surface material on blades every 100ft (30.5m). Replace wear bars and hard-
surface material as needed to protect bit holders. Change blade when bits, wear bars and hard-surface
material can no longer be replaced.
Rotating Conical Bits
1. Check bit condition using gauge (shown, 301-
1507).
A: Replace bits
B: Bits OK
2. As needed, drive out roll pin (2).
3. Remove bit (1).
4. Install new bit into holder.
5. Drive in new roll pin.
1
2
t61om016w19.eps
Summary of Contents for RT70
