Backhoe - 98
RT70 Operator’s Manual
Set Up
Set Up
Position Tractor
1. Fasten and adjust seat belt.
2. Start engine.
3. Drive to starting point. Move in line with planned job.
4. Return all controls to neutral.
5. Set ground drive speed to low.
6. Lower rear attachment to 6” (150mm) above
ground.
7. Lower backfill blade, if equipped.
8. Adjust throttle to low speed.
9. Rotate backhoe operator seat to operation
position, as shown.
10. Move to backhoe operator’s station.
NOTICE:
Backhoe may obstruct the forward visibility of the operator. Machines with limited
forward visibility should be driven only with the help of a spotter.
IMPORTANT:
Operator must be in
backhoe seat to use backhoe controls.
1
1
t63om025h21.eps
t63om025h21.eps
Summary of Contents for RT70
