![background image](http://html.mh-extra.com/html/yanmar/sd20/sd20_operation-manual_905498023.webp)
FILLING WITH
LUBRICATING OIL - SD20,
SD50 AND SD50-4T
Sail-Drive
model
SD20
SD50, SD50-4T
Standard
unit
2.2 L
(2.3 qt)
2.2 L (2.3 qt)
Long-reach
unit
2.5 L
(2.6 qt)
2.35 L (2.5 qt)
Extension 58
2.45 L (2.6 qt)
Extension 100
NOTICE: The lubricating oil capacity of the
standard unit is different from that of the
long-reach unit. Confirm the capacity by
means of the oil capacity nameplate.
1. Remove the dipstick (yellow cap). Fill
with approved lubricating oil.
2. Check the amount of lubricating oil by
inserting the dipstick as far as possible.
Do not screw the dipstick in
(Figure 3, (1)). The oil level should
reach the upper mark on the dipstick
NOTICE: It takes about 10 minutes to fill up
the Sail-Drive with lubricating oil. Check the
oil level 15 minutes after adding the
specified quantity of oil.
(1)
(2)
(3)
0005573
Figure 2
1 – Dipstick
2 – Upper Limit
3 – Lower Limit
SD20
0005441
(1)
(2)
Figure 3
1 – Oil Supply Port
2 – Oil Capacity Nameplate
SD50/SD50-4T
(1)
(2)
0005574
Figure 4
1 – Oil Supply Port
2 – Oil Capacity Nameplate
BEFORE YOU OPERATE
SD Operation Manual
19
© 2009 Yanmar Marine International