1
YH-T6 USER MANUAL
1.
Function of the keys:
Switch key: It uses to press turn off under weighing mode and press turn on under power off mode
: Accumulative-clear key: It uses to exit under calibration mode
: Kg/lb switch key: It uses to move flash bit to left side under calibration mode
Accumulative-add key: It uses to move flash bit to right side under calibration mode
：
Tare key: It uses to add the number on the flash bit under calibration mode or switch parameter.
：
Zero key: It uses to confirm under calibration mode
2. Power on and off
1).Press around 3 seconds. it begins to self-inspect, then it enters to weighing mode.
(power-on to pre-heat 15-30 minutes) If you use rechargeable battery, first you also have to power on,
but remember to charge the battery fully when using the rechargeable battery at the first time.
2).After power on, if the indicator vibrates from zero point, but it is still in auto zero range (±10% against full span),
it will come to zero automatically, then zero-point light is on; If it is out of auto zero range, you have to adjust the
zero point or re-calibrate.
3).Press around 3 seconds to exist the weighing mode.
3. Zero-setting operation:
If gross weight of the system is in manual zero range (±2% against full span), press to make the indicator
show zero, but if it has tare weight, the indicator can’t be zero.
4. Tare operation:
When gross weight is over zero and the system is stable, press to tare, the tare light is on; When the system
returns to zero point and still has tare weight, press to exit the net weighing mode, tare weight returns to zero
and tare light is off, the system returns to gross-weight weighing mode. The max accumulative weight is 999999
（
decimal point excludes
）
5. Accumulative-add, accumulative-display and accumulative-clear operation:
Step Operation
Display
Note
1
Load the goods,
when it is stable,
press ,
“
accu
”
light is on
[******]
Display accumulative weight for around 2 seconds,
“
accu
”
light is on. The max. accumulative weight is
999999
（
decimal point excludes
）
[t **]
Display accumulative times for around 2 seconds, it
means how many times you have accumulated.
The max. accumulative times are 99
Returns to
weighing mode,
“
accu
”
light is off
[******]
Returns to weighing mode,
“
accu
”
light is off,
accumulation operation ends
2
Ready to
accumulative-add again
[ 0.00]
Make indicator return to zero or tare(Note: the data
with 2-bit decimal points is an example
）
3
Load the goods,
when the number
is stable,
accumulate again
[******]
Display all accumulative weight for around 2
seconds,
“
accu
”
light is on
[t **]
Display accumulative times for around 2 seconds
[******]
Returns to weighing mode, “accu” light is off
