7
(29)
Use the dadoed 2x4’s for top
& bottom plate. The 2x4 plate on
the right; with dado’s on both the
top & bottom, is for the top plate.
(30)
Insert two 3” screws through
the pre-drilled holes to attach bot-
tom plate to each wall stud. Make
sure bottom plate and wall studs
are flush.
(28)
Locate and lay out the parts to
assemble the left wall.
Note: (Dados are 21” on center)
Assemble Walls
(36)
Place the bottom of this piece
in the correct position, again; mak-
ing sure the splice looks similar to
the other grooves. Then fasten the
corner.
(31)
Repeat the process for the rest
of the wall studs; then lay out the
siding as shown, with factory
edges; overlap/underlap towards
the center.
(32)
Starting on the top side of the
wall, align siding with both the
dado top plate & wall stud as
shown, then fasten with one 2”
nail.
(33)
Next; move along the top, to
the corner of the piece shown, fas-
ten with 1 nail, then finish nailing
along the top of this piece, using
an 8” to 12” nail spacing, before
moving to next step.
(866) 210-9273 - info@yardcraft.com
(35)
Put the next piece in place,
flush with the previous piece, mak-
ing sure the splice looks similar to
the other grooves. Then fasten this
corner of the siding, and along the
entire top plate.
(34)
Now; align the bottom corner
of the siding with bottom corner of
wall as shown, before fastening.