12
13
The charger was designed to charge battery pack between 0 °C and 50 °C. If
the battery pack is too cold or too hot, the charger will not charge. Allow the
battery to warm up or cool down.
Battery status indicators
When charging for the first time, the device should be charged for at least 6
hours.
Charging status indicator
Press the power button once (Fig. C) - front - to see the battery stat us. The
battery status 1s indicated by four blue LEDs below the power button as
follows:
• One LED =flat= do not use and recharge immediately
• Two LEDs = 25-50% capacity= recharge as soon as possible
• Three LEDs= 50-75% capacity= charge if to be used as starting aid
• Four LEDs = 75-100% capacity= fully or almost fully charged
We recommend having the battery fully charged if the device is to be used as
a starting aid. This will significantly increase your chances of success.
Charging the device(Fig. D)
WARNING!
Never use anything other than the original charger to
charge
.
1. Connect the power connector at the end of the charger cable to the DC
IN socket.
2. Connect the power supply plug to the mains electricity outlet or the
charging adapter for the cigarette lighter socket.
3. The charger can remain plugged in for a limited time after recharging
without the undesirable effect of overcharging the battery. However, when
the battery is fully charged, disconnect it.
NOTE:
The blue status lights will gradually turn on according to the charging
status and progress. If all four blue LEDs are on, the battery is fully charged.
NOTE:
The charging time is affected by discharge level and battery capacity
Charging a depleted battery can last up to 10 hours.
OPERATION
Use as a usb power source(Fig. D)
This device can be used to power or recharge a wide range of small electronic
devices.
1. Connect the device's charging cable to the electronic device
.
2. Connect the USB connector of the charging cable to the USB port on the
device.
3. Press the power button to activate USB charging.
Use as a work light(Fig. F)
This device has several different work light modes.
1. Pressing the power button for the first time turns the unit on, activates the
USB ports, and the battery status panel.
2. The second pressing turns on the primary work light.
3. The third pressing turns on the red light.
4. The fourth pressing turns on the intermittent red light.
Note
: work light panel can be pulled out as Fig G shown.
5. The fifth pressing lights up the front, focusing lights.(Fig. H)
6. The sixth pressing turns on the SOS signal light.(Fig. H)
7. The seventh pressing turns off the entire device.
NOTE:
In any of the above work light modes, you can tum off the device
by press and holding the power button for four seconds. The battery status
panel appears.
Use as a 12V power source
use the 12V output cable(Car cigarette lighter adaptor) connected to the
device as a 12V pwoer source.
Use as a starting aid(FIG. J)
CAUTION!
Always use this device for this function only with the
supplied SMART Cable. NEVER use other cables and alternative
solutions!
To achieve optimum performance, do not store this device at
temperatures below 10°C before using as the starting aid. Never
charge or start a vehicle with a frozen car battery.
1. Read these operating instructions and the operating manual/safety
manual provided by the vehicle manufacturer.
2. Use the starting aid only in a well-ventilated area.
3. Always wear safety glasses when working with batteries. Use eye
protection.
OPERATION
