54
55
•
Set cut time
This option determines the working periods of the mower in a day. A maximum
of three working periods (T1 to T3) can be set. Select a working period and then
use the number keys on the display for inputting the start and end times for each
working period.
If the mower runs out of battery power within a working period, it will automatically return
to the charging station for charging and then work again until the working period ends. It is
best to first leave the working periods as factory defaults and then modify if required after
you know the time the mower takes to completely cut the lawn. Remember that the mower
may take longer time to cut the same lawn in different seasons or under different weather
conditions.
History
There are four further options in “History”.
•
Fault
This option shows the last 4 fault records. Error information includes:
Message
Description
Low Battery
The battery power is too low to get back to the charging station.
No signal
There is no boundary cable signal.
Outside
The mower has moved outside the mowing zone.
Trapped
The obstacle sensor gives continuous alert for more than
10 seconds. The mower has stopped for safety reasons.
Pit
The obstacle sensor has triggered more than 10 times in one minute. The
mower has stopped for safety reasons.
Slope
The mower has encountered a steep slope which it cannot
overcome.
Lifted
The mower has either been lifted up or risen up over an obstacle.
Error(XX)
See the section: Error codes.
•
Cutting
This option shows the start and end times of the last two mowing cycles.
•
Charge
This option shows the end times and voltages of the last two charging cycles.
•
Health
This option shows an overview of the total working time and number of charging
cycles.
Language
This option determines the language used in the control menu. The languages available for
selection are: English, Swedish, German, Danish, Spanish, Finnish, French, Italian, Dutch and
Norwegian.
Date
This option sets the date and time for the control menu. Select the option “Date” to set the
current date and the option “Time” to set the current time. Use the number keys on the
display for inputs.
Note
：
All programmed activities and records in the mower will be based on the
date and time set in this option.
Install
This option starts the test running mode.
In this mode, the mower will mow for one minute and then return to the charging
station. After one minute of charging, the mower will start mowing again. This mode
is used mainly for setup checking.
OPERATION
OPERATION
