18
19
the dipstick is rested on the filler pipe, the oil level must be between the min and max
marks on the dipstick.
2. Start the engine and allow it to run briefly.
3. Stop the engine, wait one minute and check the oil level. Top up if necessary.
NOTE!
See more in engine manual.
Replacing the blade
WARNING!
- Before you remove the grass collection bag, stop the engine and wait until the blade
stops completely.
- You will need garden gloves (not provided) and a spanner wrench to remove the
blade.
- Always handle the blade with care- sharp edges could cause injury USE GLOVES.
- Don’t hold the blade by hand directly.
Renew your metal blade after 50Hrs mowing or 2yrs which ever is sooner regardless of
condition.
Regularly check your blade. If the cut of your grass is poor, the blade might be blunt.
Damaged blades not only result in a bad cut, they cause excessive vibration and
uneconomical running of the engine. If the blade has worn excessively and become pitted
and blunt, it should be replaced or sharpened.
1. Tip the machine slightly towards the oil filler pipe and reach under the deck.
2. Hold the blade and unscrew the blade bolt counterclockwise using a spanner wrench.
Remove the washer and the blade.
STORING AND MAINTENANCE
Fig 13
STORING AND MAINTENANCE
3. Inspect the blade adaptor on any signs of damage.
4. Fit a new blade, locate the blade on the two studs on the blade flange and then replace
the washer and bolts.
5. Check the washer is still slightly domed to keep the pressure on the bold to stop it
unwinding, keeping the blade firmly secure. Then replace the washer (right way around!)
and bolts.
6. Make sure the blade is correctly located, and then firmly tighten the bolt. Do not over
tighten. The up turn of the blade must project into the motor compartment.
NOTE!
The blade carrier is designed to break under heavy blade impact to protect
the machine. if this happens also replace the blade carrier. This can be purchased
from www.yardforce.co.uk
If you are unsure about performing this operation call our helpline or go to an
authorised dealer to change the blade for you.
Spare blades can be purchased via www.yardforce.co.uk
Storing the Lawnmower for Short Periods
The lawnmower can be stored for short periods of time (less than 15 days) without performing
any storage maintenance. Before placing the lawnmower into storage always carry out the
following:
1. Allow the engine to fully cool.
2. Ensure the grass bag is empty.
3. Clean all debris from under the mower deck.
4. Store the lawnmower on flat and level surface with the mower upright.
5. Store in a safe place which is not accessible by children or people who are not familiar
with operation.
Storing the Lawnmower for Extended Periods
If the lawnmower is to be place into storage for more than 15 days, storage maintenance
must be performed on the lawnmower. If the following steps are not carried out, when you
next operate the lawnmower it may not start correctly and may need to be serviced.
CAUTION:
Do not empty the petrol tank in enclosed areas, near fire or when smoking.
Petrol fumes can cause explosions and fire
.
1. Empty the petrol tank with a petrol suction pump if available.
2. Start the engine and let it run until any remaining petrol has been used up.
3. Change the oil at the end of every season. To do so, remove the used engine oil from a
warm engine and refill with fresh oil.
4. Clean the cooling fins of the cylinder and the housing.
5. Be sure to clean the entire machine to protect the paint.
6. Store the machine in a well-ventilated place.
