10
Hotline: 1-866-902-9690
Fig. 4
IMPORTANT:
Unfold handle carefully to avoid pinching or damaging the control cables. Control cables
must be routed above the lower handle during assembly. Please follow below steps to assemble.
1. Insert the lower handle to the two side brackets. (See Fig.3)
2. Fasten the lower handle to the device by using two arc head bolts and two fixing knobs on each side.
Make sure the control cables are routed above the lower handle. (See Fig.4)
3. Insert the quick release lock bolt into the height adjust fixing blocks on the lower handle tube (1) and
upper handle fixing blocks (2). Screw the bolt in and clamp it to fix the lower handle.
4. The handle height can be adjusted at three positions (L, M and H) by rotating the height adjust fixing
block, make sure the arrows are aligned with same position of both height adjust fixing blocks, then you
can choose the handle height level you want.(See Fig.5)
5. Push up on the cam-lock handle knobs to lock the handle in place.
6. If needed, tighten the handle nut until the cam-lock handle knob locks the handle securely.
CLIP CONTROL CABLES TO THE HANDLE
As shown in Fig. 6
Fig. 6
Clip
Attach the control cables to the handle with the clip (supplied).
ASSEMBLING THE GRASS BAG
ASSEMBLY
Fig. 5
H
M
L
Summary of Contents for YF22-3N1SPVS-SC
Page 26: ......
