12
head without the attachment.
Note:
Remove the battery if fitted before making
any adjustments.
Installing the line trimmer attachment. (See
Fig. 3 )
1. Pull out the locking pin on the coupling
connector and rotate it to stay on the collar
top.
2. Loosen the coupling connector knob by
rotating counterclockwise on the power head
assembly.
3. Align the male square shaft inside the line
trimmer attachment to the female square
hole inside the coupling connector and insert
the line trimmer attachment to the coupling
connector completely.
4. Pull out the locking pin and rotate it to leave
the collar top.
5. Rotate the line trimmer attachment until
an audible ‘click’ to tell the locking pin is in
locking position.
Note!
You may have to rotate the shaft to find
the right position for the pin to lock!
6. Re-tighten the connector knob and make
sure the attachment is fully secured in place.
Removal of the line trimmer attachment (See
Fig. 4)
1. Stop the line trimmer and remove the battery
pack from the machine.
2. Loosen the coupling connector knob by
rotating counterclockwise.
3. Pull out the locking pin on the coupling
connector and rotate it to stay on the collar
top.
4. Pull out the line trimmer attachment on any
purpose.
Installing auxiliary handle (See Fig. 5)
1. Uninstall the bolts on the auxiliary handle.
2. Install the auxiliary handle on the Shaft and
then tighten the bolts with nut and make sure
the auxiliary handle is firmly secured in place.
OPERATION
Inserting and removing the battery pack
To insert the battery pack
1 Align the groove on the battery pack with the
corresponding mounting ribs and press the
battery pack down until you hear a “click”.
2. Check to make sure the battery pack is firmly
secured into position.
To remove the battery pack from the tool (See
Fig. 6)
1. Depress the battery releasing/locking button
on the housing.
2. The battery pack will pop up automatically.
3. Lift and hold the battery pack while pressing
the releasing/locking button again, and then
remove the battery pack.
Note!
The second operation that needs to be
performed when removing the battery pack is
to avoid any misoperations at work, especially
for the 60VRX hand-held tools, in case the
battery pack falls and hurts consumers.
Switching On/Off
WARNING!
Before operating the unit, remove stones, loose
pieces of wood and other objects from the cutting
area.
To switch ON(See Fig. 7)
1. Depress the safety lock button-A and
squeeze the switch trigger-B at the same
time.
2. Select your required speed setting by
depressing the speed adjustment button.
3. Move your thumb away from the safety
button.
To switch OFF
- Release the on/off trigger switch.
NOTE:
Always switch off line trimmer before
placing it down.
Speed adjustment (See Fig. 8)
This line trimmer has 3 speed settings which can
be changed with a press of the button.
1. Ensure the line trimmer is switched ON.
2. Press the speed adjustment button and set to
your desired cutting speed.
3. If the speed is set to the highest speed, press
the speed adjust button again and this will
reduce to the lowest speed.
