11
Lubrication
WARNING: Always stop engine and
disconnect spark plug wire before
cleaning, lubricating or doing any kind of
work on edger.
Engine
Refer to the separate engine manual packed with your
edger for detailed instructions of all engine-related
maintenance & lubrication.
Wheels
Lubricate the wheels and bearings at least once a
season with light oil or engine oil. Also if the wheels are
removed for any reason, lubricate the surface of the
axle bolt and the inner surface of the wheel with light oil.
Pivot Points
Lubricate the pivot points on the blade control handle,
curb wheel control lever, blade depth control lever and
the blade adjustment lever with light oil at least once a
season.
Cutting Head Bearings
The two ball bearings in the blade spindle housing are
lubricated and sealed at the factory and require no
lubrication. Lubricate all other moving parts with a light
oil.
Spindle Shaft
Lubricate the two bearings and under the compression
spring on the shaft with light oil frequently during the
season. Do NOT allow rust to form in this area.
SECTION 7: OFF-SEASON STORAGE
Observe the following when preparing the edger for
long-term storage:
•
Clean and lubricate unit thoroughly according to the
lubrication section.
•
Refer to the engine manual packed separately with
the edger for engine storage instructions.
•
Coat the edger blade with chassis grease to
prevent rusting and corrosion.
•
Store the edger in a dry, clean area. Do not store
next to any corrosive materials, such as lawn
fertilizer.
•
Coat the edger, especially any springs and
bearings with a light oil or silicone spray.
IMPORTANT:
When storing any type of power
equipment in an poorly ventilated or metal storage
shed, care should be taken to rustproof the equipment.
