9
Trenching
Set the blade tilt control lever (refer to Figure 8) in the
fourth or fifth notch to place the edger blade in position
for trenching. See Figure 11.
Figure 11
Edging Along A Curb
(models so equipped)
NOTE:
Edger features vary by model. All edger models
do NOT come equipped to edge along a curb nor is
there a curb wheel kit available to modify your edger if it
was not purchased equipped to do so.
To edge along a curb, lower the right rear wheel by
moving the curb wheel control lever toward the rear of
the unit, pivoting the wheel to the desired depth and
releasing the lever. See Figure 12.
When edging along a curb, the edger will ride on the
two rear wheels and the support roller located beneath
the edger base, behind the blade. The wheel at the
front of the edger is NOT used when edging along a
curb. See Figure 13.
Figure 12
Figure 13
Trenching Position
Curb Wheel Control Lever
(Normal Operating Position)
Curb Wheel Control Lever
(Lowered Position)
