Page of 20
13
IMPORTANT: Do not
over bend the support rods during the following step. Over bending will cause the
steel rods to lose supporting tension.
(Figure 16)
Tip the hopper onto its back to assemble the two hopper support rods. Place the ends of
each rod into the upper and lower rear hopper tubes, bending the rod just enough to fit into the holes in
the tubes.
(Figure 17)
Insert the Front Support Rod through the
top
hole in each upper hopper side tube and
assemble the bag arm tube and secure it with an Ø3 R pin (N).
16
17
