15
** Clean filters and air intakes more often in
dusty conditions or when there is high
density of airborne
* Not required unless engine performance
problems are detected.
Replacing Power Belt
1.
Stop the engine, disconnect the spark
plug and check that the engine has
stopped completely.
2.
Remove the bolts holding the belt guard
and remove.
3.
Loosen the bolts holding the engine at its
base.
4.
Adjust belt tension by loosening the
ensioner bolt unscrewing basis, use a wrench
9/16 " hex wrench.
5.
Proceed to replace and adjust tension
again until it is felt tight by pressing down
with the finger.
6.
Bolt the belt guard in the same way it was
disassembled.
Cleaning of the equipment
Carefully clean the cutting chamber after
each use.
WARNING
The rotor blade is sharp. Wear
leather gloves to protect your
hands when cleaning the cutting
chamber.
NOTE: Blasting pressurized water is not
recommended.
Taking care of your engine
NOTE
: Review the sections of maintenance
and operation of the engine manual for
detailed instructions.
1.
Check the oil level.
2.
Clean the engine regularly with a
cloth or brush. Keep clean the air
intake system to allow proper air
circulation. Remove all grass, dirt
and combustible debris from muffler
area.
SERVICING
Rotor Blade
WARNING
The rotor blade is sharp. Wear
leather gloves to protect your
hands when the cleaning cutting
chamber.
Blade re-sharpening
1. Stop the engine, disconnect the spark
plug and check that the rotor of the chipper
has stopped completely.
2. Open chipper loosening the lock knob.
3. Remove the bolts securing the blade to
the rotor using a 5mm Allen key and a 9/16”
hex wrench.
4. Remove the blade and proceed to
change or blade sharpening.
5. Blade must be sharped at a 30deg. angle
and must not overheat to loose its heat
treatment properties.
6. Tighten the bolts again.
NOTE:
To remove the blade’s bolts, it is
recommended to place a piece of wood in
between the rotor and the outside edge to
Summary of Contents for YB2510
Page 23: ...23 NOTES...