22
support@yardistrystructures.com
3
4
1
2
AE
Step 10:
Fasten Roof Panels & Roof Edge
Position roof panel on frame with outer edge flush with Wood Rafter. Push panels against Roof Cap Bracket. Check that panel square to frame. Starting
from corner 1 , fasten roof panel to Wood Rafter with Hex Roofing Screw #8 x 1" do the same at 2 . At 3 use Self Tapping Screw #8 x 5/8". To fasten to
Steel Strap. Support frame to prevent bending.
(1) 250-Roof Panel
(2) Hex Roofing Screw #8 x 1"
(1) Self Tapping Screw #8 x 5/8"
Scrap wood blocks (not supplied) to support assembly when driving tapping screws
3
4
1
2
AE
Step 10:
Fasten Roof Panels & Roof Edge
Position roof panel on frame with outer edge flush with Wood Rafter. Push panels against Roof Cap Bracket. Check that panel square to frame. Starting
from corner 1 , fasten roof panel to Wood Rafter with Hex Roofing Screw #8 x 1" do the same at 2 . At 3 use Self Tapping Screw #8 x 5/8". To fasten to
Steel Strap. Support frame to prevent bending.
(1) 250-Roof Panel
(2) Hex Roofing Screw #8 x 1"
(1) Self Tapping Screw #8 x 5/8"
Scrap wood blocks (not supplied) to support assembly when driving tapping screws
Hardware
#8 x 1” Roofing
Screws (pre-drill
before installing)
Step 8: Attach Roof Panels
Part 1
F8.1
F8.2
4 x #8 x 1” Roofing Screw
2 x #8 x 7/8” Self Tapping Screw
Roof Parts
2 x Main Panel
Side View
DO NOT overtighten
screws, could cause
damage to roofing
material
Slight
overhang
Note: Be sure to remove all plastic covering on both sides of the metal panels directly before installing
each piece.
A:
Place (879) Left Gable Upright and (880) Right Gable Upright under frame to prevent it from bending when
installing screws. These pieces will not be installed until Step 10.
B:
Place one Main Panel on Roof Frame Assembly, under lip and tight to the top of Roof Cap Bracket and flush
to sides of (877) Rafter. There will be a slight overhang at the bottom. There are no holes on the ribs at the top
of the panels. Pre-drill with a 1/8” drill bit then attach Main Panel to (877) Rafter with two #8 x 1” Hex Roofing
Screws. Be sure not to overtighten screws. (F8.1 and F8.2)
C:
Attach Main Panel to Roof Strap with one #8 x 7/8” Self Tapping Screws in location shown in F8.1. Be sure
not to overtighten screw.
Flush
Roof
Strap
Main
Panel
Bottom
Top
No Screws along
bottom row
#8 x 7/8” Self
Tapping Screw
Main
Panel
(877) Rafter
(877) Rafter
Roof Cap
Bracket