11
DOO
R
6"
(15,2 cm)
12"
(30,5 cm)
12"
(30,5 cm)
96"
(243,8 cm)
Move to the opposite side. Using the long edge of the panel as a lever, move the
panel side-to-side until the top corner is flush to the floor frame
(Fig. B)
.
Use the Gauge Block to maintain the 3/4" measurement along the left edge.
Secure panel with two 2" nails in the corners.
2
BEGIN
1
3
4
Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Fig. C
Check that the floor frame is square by measuring diagonally across the frame corners. If the measurements are
the same your floor frame is square. The measurement will be approximately 153-11/16" (390,4 cm)
(Fig. C)
.
PARTS REQUIRED:
x1
5/8 x 48 x 96"
(1,6 x 121,9 x 243,8 cm)
x53
2" (5,1 cm)
FLOOR PANELS
153-11/16"
(390,4 cm)
153-11/16"
(390,4 cm)
Attach the 48 x 96" panel with the 48" edge and corner flush to the floor frame
(Fig A)
.
Secure panel with two 2" nails in the corners.
Fig. B
Flush
(2)
Nails
(2)
Nails
3/4"
3/4"
Ensure your floor frame is square by installing one panel and squaring frame.
Install panels with rough side up (painted grid lines).
Grid lines up
Flush
Fig. A
Flush
5/8 x 48 x 96"
(1,6 x 122 x 243,8 cm)
3/4" GAUGE
BLOCK
3/4"
GAUGE
BLOCK
