15
PARTS REQUIRED:
x66
2" (5,1 cm)
x6
1-5/8" (4,1 cm)
RAFTER ASSEMBLY
x6
6 x 24" (15,2 x 61 cm)
GUSSET
x6
2 x 4 x 75-1/4" (5,1 x 10,2 x 191,1 cm)
ECN
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
ECN x2
ECN x2
Fig. A
Fig. B
Fig. C
Keep rafters firmly against
CLA
at both ends when securing gusset.
Repeat steps 1 through 3 to assemble two more rafters.
Flip rafters over and attach a second gusset using glue and (12) 2" nails. No need to use jig for 2nd gusset.
4
3
2
Keep
ECN
firm against outside
CLA
's as shown
(Fig.A)
. Rafters should touch at tips
(Fig. A)
.
Apply glue to rafters where gusset will attach
(Fig. B)
.
Place gusset onto
ECN
holding a 1/4" gap from edge
(Fig. C)
. Secure gusset using one 1-5/8" screw into each
rafter.
HINT:
These screws will help hold the measurements when you nail on gussets.
Use (12) 2" nails to finish securing the gusset to the rafters to pattern shown in
Fig. C
.
BEGIN
¸
1
Place two rafters
ECN
into the jig as shown.
1-5/8" (4,1 cm)
Screw
120-3/4"
(306,7 cm)
Glue where
gusset installs
