3
OPTIONAL MATERIALS
DRIP EDGE ..................... 50 Feet
#15 ROOFING FELT
To cover 128 Sq. Ft. of roof area.
1" GALVANIZED ROOFING NAILS.........1/4 Lb
For roofing felt.
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER’S INSTRUCTIONS FOR
INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
COMPLETING YOUR SHED
You will need these additional materials:
3-TAB SHINGLES ............................. 5 Bundles
PAINT FOR SIDING .......................... 2 Gallons
Use 100% acrylic latex exterior paint. (2) coats recommended.
CAULK .............................................. 2 Tubes
Use acrylic latex exterior caulk that is paintable.
1" GALVANIZED ROOFING NAILS.... 2 Lbs
For shingles.
PAINT FOR TRIM .............................2 Quarts
Use 100% acrylic latex exterior paint.
WOOD GLUE ....................... Exterior Rated
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
WOOD FLOOR FRAME
IMPORTANT!
Depending on your specific use you may want to construct a
heavy duty floor frame by adding additional floor joists (shown below as shaded).
Below is a list of additional materials (not included):
x2
x8
2 x 4 x 8' (5 x 10 x 243,8 cm) Treated Lumber
Cut to (3) 2 x 4 x 117" (5 x 10 x 297,2 cm)
ea. 3" (7,6 cm) Hot Dipped Galvanized Nails
Optional 12" (30,5 cm) spacing
Standard 16"
(40,7 cm) spacing
FOUNDATION OR FLOOR MATERIALS
ADDITIONAL MATERIALS
• This shed
does not
include any floor or leveling materials.
• See the FLOOR LEVELING section on page 7 for recommended methods and suggested materials to properly level your floor,
as this will vary depending on your specific site.
NOTE: Use a minimum of 5/8" (1,6 cm) Oriented Strand Board (OSB)
5/8" x 48" x96"
(1,6 x 121,9 x 243,8 cm)
x3
FLOOR PANELS
You will need floor panels and nails to complete your floor.
Floor panel sizes and quantities are shown below.
2" (5,1 cm)
x1
1 lb. of 2" (5,1 cm) Hot
Dipped Galvanized
Box-Type Nails.
•
Cut 1 panel to 24" x 96"
MATERIAL REQUIRED:
Use only wood treated for ground contact and fasteners approved for use with treated wood.
x2
2 x 4 x 120" (5,1 x 10,2 x 304,8 cm)
Hot Dipped Galvanized Box-Type Nails.
3" (7,6 cm)
x36
x9
2 x 4 x 96" (5,1 x 10,2 x 243,8 cm)
