48
BACK GABLE
PARTS REQUIRED:
3" (7,6 cm)
x4
3"
(7,6 cm)
Screws
You have fi nished attaching your back gable.
FINISH
Working inside, secure gable unit with 3" screws toe-screwed into
UV
at an angle as shown in
(Fig. B)
.
3
2" (5,1 cm)
x37
UV
Fig. A
Fig. B
TOP PLATE
LEVEL
NAIL FIRST
2" (5,1 cm)
NAIL FIRST
2" (5,1 cm)
6"
(15,2 cm)
Back Gable Unit
BEGIN
1
2
Continue nailing lower edge of panels into top plate using 2" nails 6" apart as shown
Secure upper edge of panels into rafter using 2" nails evenly spaced as shown
Set back gable unit on top plate, centered on wall, resting on 2 x 4 gable supports
UV
and over-door trim
(Fig. A)
.
Hold gable secure with one 2" nail on each side as shown.
BE SURE GABLE IS CENTERED ON WALL
BEFORE NAILING.
